Recent content by Dman1981

Start it up cold dead head cylinder on hydralics see if it gets hot where piston is Or fully extend it pull head line and cap it see if oil keeps running out when you dead heap again if oil keeps shooting out Don't cap cylinder just line

You also need to push seal over rod lip on inside or it will just keep seeping

you have to take out three gears or one with wider opening then there are lock rings on top of stub axle knock the off Then if your lucky it will let you pry off if not you have to press it off sometimes heat the housing to get it off Mf makes a tool threaded shaft and tapered nut to pull them...

Not really that many wires get a diagram make your own

3241F102 injection pump came off a MF 50ex will fit other models also. Was working Great when I took it off. unit was salvaged Make me an offer plus you pay for shipping live in Southern California

I helped FLEXXAIRE with dimensions on the kubota m5 and a wacker neuson St40 great people to work with and listen to all Input their fans are flawless have over 2900 hours on both m5 and wacker has 1200 have a self timer set For every twenty minutes which can be changed also have manual switch...

I have installed and repaired quite a few FLEXXAIRE fans they work really well you still need to do a good clean out once in awhile but will keep you in the seat They can run off hydraulic or air I plumbed all mine to hydraulics only takes 200 to 300 psi to switch plus it comes with a valve so...

I put valve seals on all the valves They came in the Perkins kit years ago of course kit was only 200 dollars

Does it leak down when you shut off tractor or hold?

Did you find a shaft yet

75-140 is gear oil just use the synthetic pricey but worth the money They sell in 80 90 weight also But use what you are comfortable with

I use 75-140 synthetic in everything But I do live in ca where it's hot then hotter

https://www.facebook.com/reel/3839308792955314/?mibextid=rS40aB7S9Ucbxw6v

Are you using ninety duro orings or?