Recent content by DiskDoctr

Sounds reasonable. My rims are pretty beat up and found them to be very 'soft' = especially when fitting or removing tires. Had some punctures over the years, so on and off for tubes and now for tires. Won't hold air tubeless any more. I do work with a lot of shale and clay mix, so no shame...

Thank you for the offer, but that is a bit pricey. Titan makes them. "Most" tractors in this size have switched to 16in- just from observations and mfrs seem to have standardized on that size. Weather permitting, I will remove the wheels tomorrow and take to local shop for the tubes and...

Does it cross to John Deere LVA13715 LVA13715: Rim, 7 X 15 | LVA13715

15x7JA - What does it cross to?

Still looking....

Had similar problem with 3510 a bit ago. Pulled radiator, had to wash out the fins for a long time. Placed it on top of bucket so water flowed from 'back' to front, used dawn water and fresh water at garden hose pressure (used nozzle to reduce, not full power to bend fins) and rinsed repeatedly...

Any sources for front wheels/rims for 2004 3510? They are 15 inch, not 16 inch as the later models. Not sure if they are bolt pattern compatible with (??) It is 4WD, so can't really go with 16" without problems either with drive ratios to the rears or much shorter tires- if they even make...

Thanks! ...also for the 'translation' Lol

Tube. Tires are new Carlisle Trac Chief 28/8.50-15 C The tubes are supposed to have valves designed for fluid/ballast. The stuff you linked is preventative to stop punctures, right? How many are needed for the tire tubes?

I found a pic I took of the tube I took out of it. It had been in the tires for about 10 years or more. One was even patched once and put back in. I ordered two replacements to be here by the end of the week. My tire guy couldn't get them right now, so Amz* to the rescue! Amazon.com

About 8hrs on new tires and tubes and one tube burst. 28 x 8.50 x 15 R4 industrial tires. Apparently cannot handle the front loader weight. We wire brushed and cleaned entire wheel to make sure no burrs. So now looking for heavy duty tube and/or no-flat product that will handle the weight...

Still not sure about the airbag though. I am sure it is completely discharged now, but what about when I plug it in?

My coolant reservoir cap is broken. Looking for a replacement cap or reservoir. Are there other container lids that will fit? (ie peanut butter jar for canning lids) $20 to replace cap, $80-200 to replace the PLASTIC reservoir. Ugh.

Only in 21 states! Lol

Yep! Thinking about using the existing square mount that will allow it to swivel and adjust up/down.