Recent content by dh0765

I have a Jinma 224 that only has 8 hours on it. I keep blowing the main fues every time I try to start the **** thing! As you can tell, I am a little frustrated. I have looked at everything I can see and don't see any wires touching anywhere, but everytime a put a new fuse in, I can turn the...

Hi, I have a Jinma 224 4x4 with ag tires. The rear tires say 250 KPa cold max and the front say 450 Kpa cold max. If I am calculating correctly, this would be approx 36 PSi in rear and 65 PSi in front. Can someone confirm this?

I am having a problem with the PTO not fully disengaging. When I move the PTO lever to Neutral, the PTO shaft continues to turn, but not a full speed. I can stop it by putting something against it, but when I let go, it starts to turn again. Any help is appreciated.

I have a Jinma 224 tractor with only about 6 hours on it. I noticed hydrolic fluid leaking around the right rear lift arm. I just figured that it must have been a bad seal. I obtained a new seal, pulled the lift arm, bushing, and old seal out. Installed the new seal, reinstalled the bushing...

I have a couple questions regarding my new 224. Question 1, I have seen all kinds of post on the service of fluids. My question is, on the 4WD 224, where do you check the front end fluid at and where is the drain located? I can't seem to find any info on this. Second question, I already...