Desert Moose's latest activity

You are more than welcome. I hope it works for you.

That's correct, this fixes a non-pull in. In my case the hold in circuit was still working fine, it just didn't pull in. If it's the...

I don't think pictures would show much, so I did a sketch instead. It's pretty simple. I did run the new wire inside a piece of wiring...

I'm always in favor of a creative workaround to help beat the system. Been there, done that, more times than I care to count.

Well, the new timing relay didn't fix it. I'm thinking there's some corrosion in a connector or something cutting down the voltage to...

OK, without a wiring diagram, I'll just have to look and find what's the best approach. Thanks for the ideas.

I might try it. would be easy to do, just add a jumper wire once I find the right wire to connect to.

That would be easier, I was not sure if the solenoid could stay energized longer than the original 1 second without overheating.

OK, I found a third relay, doesn't look like a relay, but with better light I found it. It's a timer relay, so might be the one to pulse...

I don't think the new solenoid comes with the 3 connector pigtail with wires. It only has the 3 pin plug on the case. Maybe I could...

OK, more information. I hooked a jumper up to the contacts on the solenoid, one at a time, grounded the case on the negative terminal of...

I bought my CK12HST in march of 2007. Been great for all this time. However, it has become hard to start. Turns over just fine, just...