Recent content by dayjd1

For the last couple weeks I have noticed my bucket coming up slower and with my forks attached to the bucket it tends to come down when the tractor is off. Recently even if the tractor is running it still wants to lower itself. It does not raise as high as it use to and it lift capacity is much...

I purchased a used 273 and got a pretty decent deal on it but I think the biggest factor that influenced my decision was because TYM is a ISO9001 manufacturer. I am very familiar with this type of world class quality and a company and its workforce must do a lot of hard work to achieve this...

Wow, Finally got a pic to upload. have to try again .......... I guess my pics were too large before??? Reduced them 50% and they uploaded.

Anyone have any information on where to purcahse such a item? Thanks, Bill

About 36 inches of fresh snow. Everything worked beautifully and I cleared a 600 ft paved driveway in about a hour. Could of made a little better time if the darn wind wasn't blowing or at least wasn't blowing in all directions at the same time. Thinking a cab would be awfully nice but we don't...

It blows snow excellent but now my PTO wants to kick out after a few minutes of blowing snow. If I push the PTO button on the dash wall it will kick back in, but kick back out a few seconds later. Any ideas on what is goin on? Thanks, Bill

But I replaced my glow plugs and what a difference. Had two plugs that were dead. Also thought it was pretty hard on fuel so could I expect improvement with the new glows?

I'm in the process of installing a TYM 60" snowblower to a TYM273 tractor .......... It is a front mount and also requires me to install a mid PTO which basically requires me to drop the pto bottom plate and bolt this new gear box in its place. My question ..... I need to drain the fluid from...

I find alot of info here but the new incoming or requested information seems to flow like molasses. Much slower than other types of forums that I have been a member over over the last 10 - 15 years. Maybe it's just because the TYM tractor is not that popular here in the U.S Maybe a question to...

New to this tractor world and I'm about to install a 60" TYM snowblower. I can't seem to unattach the FEL and I have been unable to find any instructions. He is what I have done so far...... Lowered the FEL to the ground on a level surface. Set the safety legs and unhooked the hydraulic...

I know it was made and South Korea and Assembels in China:( The previous owner said he purchased it new in 2009. Anyone know where on the tractor this info can be found?

I am looking for a front mount snowblower that will quick attach to a TYM273. Anyone have any suggestios? Thanks, Bill