Cycledude's latest activity

You can get sleeves to reduce the size of the lift arm holes. https://www.qualityfarmsupply.com/collections/lift-arm-bushings-balls

I own both HST and gear driven, prefer HST most of the time. But if your wanting to pull a lot of heavy loads a long ways at road speeds...

Sell it or give it to someone that’ll take good care of it.

Unless you have to wear glasses then all the over the head muffs loss most of there effectiveness.

Unfortunately, at only a 17 NRR, I'd put that in the "kind of sucks" category. Certainly better than not wearing hearing protection at...

I had lots of ear problems as a kid and HATE putting anything in my ears. I do, however love the HF hearing protectors and use them all...

Well, I learned something from you folks. Now I know what that little knob that has a picture of a turtle and bunny is for! I did have...

Well went for a ride to visit some friends yesterday, pretty hot the highest temperature I saw was 87 degrees Fahrenheit with very high...

Power Trac is a very interesting machine but seems like almost everyday I’m reading about one that’s broke down somewhere and no parts...

Interesting article...

I have also tried both high speed and low speed for starting the blades on my Kubota ZD21 , high speed definitely seems to work better...

“ Kohler manufactures internal combustion engines at several locations worldwide . Their primary facilities include: Hattiesburg...

Tipping culture has gotten out of hand. What next? I'm expected to give the self checkout machine a tip too? You see the big chain...

The push button PTO shafts seldom cause me any trouble but the sliding collar types are almost always trouble for me when hooking up...

If your loader is a ML112, the rod has a large flat washer welded to it on the bucket end and mounts to the upper bucket pin. You can...