Cub Cadet TN's latest activity

Update! When the deck was attached, the weight was enough to re-engage the deck pedal. I was able to lower the deck completely and...

Addendum - it is stuck all the way up at transport height.

Putting on the mulching kit. Everything smooth. Lowered deck all the way. Step 4(e) in picture. Stuck wrench into alignment holes to...

Oh, I did my research. No offense taken! I wanted the small one cause I have a lot if nooks and crannies to get it into and out of...

Amendment - I have the ZTXS4 48.

Getting ready to do my first oil change - after break-in period of 10 hours. I was able to find one quart of 10w-50 at TSC, and they...

Update - i took a Dremel and cut the extra pair of springs to where they would be the same height as the OEM "springs" - problem solved...

Picture three

Picture two

Here is the picture of the clampy thing and the latch. Sorry for the bad pictures. That latch hits just above the bracket behind the...

There is a clampy-type thing that latches on the back of the seat, and you normally have to move the lever to release the clamp and...

If I cut the bottom, I need to find a bigger washer. If I cut the top, not sure that the cap thingie will still fit. But worth a try!

I have an extra pair that I can test on. Maybe a good set of bolt cutters. Did not know if that would mess up the spring or change its...

Saw all the videos. Wanted to put the motorcycle springs under my seat. They look and feel amazing. Only problem - they are a smidgen...

I ordered these little hooded umbrella type keys (fishing plug not included) for about $6 for a pair to hopefully keep dust and dirt out...