CoyPatton's latest activity

If like me, you own an older tractor that’s engine was designed for sulfur based diesel then likely you have lost some lubrication from...

Mist Most 3ph’s use gravity/weight for their down force. Double check yours by hold an non implement attached arm up and operate the...

I own a Yanmar YM2002D. I have never had this problem with my tractor, but have read in forums (from the former Hoye Tractor site of...

If it were me, I would check my current valve for size and hose placements and do a bit of shopping. I looked at Summit Hydraulics and...

The last above ground pool liner I did, I put down I think it was 3 layers of fan insulation on top of a layer of plastic, on top of...

Don't use a nut. Cross drill it and use a hitch pin.

In my opinion and limited timber experience, you need several pieces of equipment. 1) a tractor, to mow and maintain existing roads...

My tiller I’m sure is a Chinese tiller, as it was listed in mm, approximately 53.5” in tilling width. I have had it for around 15 years...

Years ago, no longer gave that property due to divorce, I had a dead tree that didn’t branch out until much higher. About 25’ tall...

Start stacking all your limbs and brush and whatever around the base and when you get a good pile burn it.

Set the bland down leaned against a low object (I have used stumps). Disconnect and swing the lift frame around. Then hook back up. Yes...

Totally agree, there is no 1 answer fits all situations. Explained very well!

Well, both are correct in certain circumstances. Super-light machines are very different than minis that way tons: you can easily drag...

Remember in your childhood, around me we called them seesaws. They should have taught you at a young age the effect of levers. I have...

Well for me my burn location is in an area where the row crop farmer that farms the land usually sprays when they spray the crops for...