I'm looking for a good aftermarket alternative for my NH T4.75 top link. It seems that the one's I can find online or in local stores are smaller cat 1 type top links that aren't quite what I need. Does anyone have experience with this, or have an idea of where I could look for one? The...
Hello all,
I've recently acquired a Woods RB 96.60 with hydraulic angle and offset, manual tilt. I would like to have all three hydraulic functions, but my tractor (NH T4.75) only has two remotes on the rear. I've checked prices before on adding another rear remote and it was ridiculous.
I'm...
Thanks for the comments. I ordered all the couplings and fittings/adapters today. I plan to get the bracket at the mid mount fabricated and installed, then measure all hose lengths needed.
I think I'll go with r16 hose. I think the added flexibility would be nice on the 1/2" hose vs. R2, and...
Hello all,
I'm going to run a couple 1/2" hydraulic lines from one of my rear remotes to my FEL to power a SSQA hydraulic auger. I'm looking for help identifying the correct fittings/adapters I'll need to make it happen. I plan to put a disconnect at the mid valve point. Currently my loader...
Hi all,
I have a NH T4.75 that came with 2 rear remote valves from the factory. I would like to have a 3rd functional valve on the FEL to operate hydraulic SSQA attachments. I would also like to have an extra remote on the rear or the tractor for a 3-way hydraulic blade (angle/tilt/offset)...
Hello all,
I'm looking for some experience and advice on using a skid steer style hydraulic auger post digger mounted on a front end loader. I've been thinking long and hard about adding a 3rd functional valve on my FEL of a NH T4.75. The 3rd functional valve kit is actually cheaper than...