Carl_NH's latest activity

So you replaced the filter without shutting off the fuel, I guess? That eliminates air and its not leaking any now after replacing the...

When you installed the new fuel filter, did you let the small canister fill with diesel before tightening the bowl? That eliminates any...

BCP yes that is an interesting list - I thought there would have been more private jets, G550 etc but those go fast and land, and sit...

Don’t see these often- took off from Columbus oh

As 5030 and PTSG point out it may be possible to remove the covers and drive out the pins in couplings and have enough wiggle room to...

Jeff are you talking about the front wheel drive shaft or the main drive shaft for the Clutch/HST? If its the main drive shaft and...

I added the WR Long 3rd Function a year ago, and yes, had I known it was so simple, I would have bought the parts like you did. It was a...

Looks really good - nice, clean installation!

Glad you got it fixed up, and the right tools - a big and little hammer!

Here's a couple of machines in WA that look close to your specs...

I'm ready to start running my pex: Used one of those foam heat knives to take off some nubs where the manifold will be located.

I would be looking for a 2000-2500 hr machine 8-10 years old like the Takeuchi 260, Bobcat e50, JD 35 or 50G, Cat 303.5 or 304/305 size...

Nice looking machine Matt - yes they are slow but you knew that going in. The blue looks good - seems to be a Hightop made unit. I see...

Please change the air filter position while your at it - the clean out is meant to point down.

Agree with you LBBJ - thru the wall for the line sets and usually a electrical disconnect box next to the compressor. As far as the air...