Got it all back together thanks to you guys. Hopefully it actually works.
Breaking the nut was a real pain in the sack. I had to put the clutch back on the gear box, then I used a ratchet strip to keep the blades from turning.
I used my big a channellocks and a 4 ft cheater bar to break it...
You guys are awesome. I ordered two discs from qualityfarmsupply. I need a new bolt. Would it be ok to replace them with stainless? None of them had locknuts, but they were cinched down pretty good / hard to remove.
Thanks, yes I know nothing. So it is slipping. I removed it. It looks like there were 2 gaskets in there and they have both deteriorated. There are 4 bolts attaching it and 1 was missing.
I have an older rotary cutter. I don't see a brand name, but it has the following ID:
T 660 LT
T816/443B
The Gear Box says "Auburn Gear" 2102-N
So the question.....where can I find the part in image 002?
The plates around the middle plate are not spinning with the PTO shaft. It looks like I...
I haven't been able to start my tractor since it has warmed up.
Question 1) What is "ST" on the ignition switch? There are four positions beside the ignition switch "ST OFF ON START".
Question 2) I'm pretty certain that my glow plugs are not working. Do they need to be hot in order to...
This is the best I can do for now. I was just looking at mine Saturday and I took this poor quality picture. If you don't already have it figured out, I could get better information Tuesday.
I just purchased a Mitsubishi D1800. The guy I bought it from said he had not used it in a year and a half. He had it for 3 years and used it a few times to use a 4' bush hog. He had it running when he posted it to sale. I went to look at it, it fired up rather easily, and I took it for a...