Recent content by blackd

The fuel filter housing is susceptible to damage from below. Doing some downed tree clean up I caught a branch between the frame and motor it hit the FF housing. It rotated 90 degrees breaking off the output nipple. It's a simple fix. Just one bolt for the housing and two snap rings for the...

I have used a Caroni 48" tiller pulled by a GC2400 for ~10 years. The combo is VERY efficient with one exception. The overrun clutch needs annual adjustment now after busting several tree roots after breaking new ground 4 years ago. Other than the clutch wear the Caroni shows no wear at all.

I found this: 3708896M1 - PAD fits Agco | Price: $6.70 for $6.70

I've rebuilt my spindles on multiple mower decks many times. Yes, I've rebuilt spindles on several decks, including my MF 2325 [60"] mower deck. IIRC, the bearing is a sealed 5205. 5205 bearings for sale | eBay They are readily available, and not too hard to replace. The critical...

Before replacing/cleaning the carburetor check the Intake Joint O ring. Suddenly my 2005 Kodiak 450 started having problems starting and running. It acted like it was running out of fuel and leaning out with hard start. I immediately thought it was the carburetor needing a cleaning, so...

Tiller's on the tractor and tested it by tilling the food plot yesterday. I will remove fence ends on veggie garden, fertilize and and till it today. Yesterday's high temp was 78 and today's will be ~81, so time to get the early crops in the garden.

If they are Quick Connects they may only need new O Rings. Let us know and pics do help.

I have a MF GC2400 pulling a 4' Caroni, just slightly wider than the tires, used in a 40' square fenced garden and a slightly smaller food plot for deer. I till the garden twice annually, Spring and Late Summer/Fall. I take down the 7' deer fence on each end to till close to each end where the...

Good for 4 hours continuous service on a charge? Doesn't mention how long to charge, but is 4 hours enough to justify for most uses?

So my little 22.5HP MF might take as long as 1 week's worth of electricity to charge?

Sorry, it's been too much time to remember or find any receipt. I also have the 2320 deck for sale on CL, since I haven't used it because of getting a ZT mower.

Yes, I got the Bro-Tek plate.

I did not, but do now have the skid plate for my GC2400. I knocked the hydraulic filter off the tractor, and when this happens it often takes the filter nipple with it. That nipple is cast into the front transmission plate. The traditional repair is to replace the plate, and it is expensive...

Remember that skid plate to protect the hydro fan & filter. ;-)