I have a Kubota B2150 which is fairly new to me. Currently, it doesn't have a FEL (or any hydraulic implements). If I were to locate a FEL to fit the tractor, what modifications would I need to make to the tractor? The only hydraulics it has now is to operate the 3 pt. hitch. Thanks.
I'm trying to get information about an older Land Pride mower (SN 7986). I've looked around online and haven't been able to find out much about it. Trying to find out approximately how old it is, etc, in hoped of posting it for sale. It's in pretty good shape and has been stored indoors over the...
I had someone weld the end of a weightlifting bar to a piece of steel and bolted it to the front of the tractor. I can add and subtract weight as needed. You can buy 45 lb weights at Walmart for ~$30. Easy to remove the bracket when not needed.
I have a B2150 with turf tires and a 3pt snow blower mounted. I ordered a set of rear ladder chains but didn't realize that I didn't have enough clearance between the tires and fenders to use them. There's only about 1" of clearance, as is. Bro-Tek sells 2" spacers for this tractor. A couple of...
I need to replace the oil pressure switch on my Kubota B2150. I have the part ordered. Is the replacement pretty straightforward or is there anything I need to be aware of? Looks like just backing the old one out and replacing it with the new one? Thanks
I'm trying to figure out the easiest way to add a block heater to a B2150. One side of the engine has a couple of freeze plugs, which I am hesitant to remove. I've seen mention of a plug which screws out using a 17 mm hex wrench, but can't find one. I did however find a plug with a raised hex...
I have a Kubota B2150 with turf tires and a 60" rear blower mounted on it. I've added front weight to even out the weight distribution. My gravel driveway is mostly flat but has one short, steep hill in it. I'm considering getting chains for it. Would standard ladder chains work ok or should I...