Recent content by bigroccrek

Thanks for the response, I suspected it was a pressure relief valve. It appears to be leaking in one of two places (see pics below), kind of hard to tell since I cleaned it up. I may just try snugging it up a little and see how it responds. If it still leaks I will pull it and replace the...

Thanks for the response. You have confirmed my suspicion that it is a pressure relief valve. Thanks again!

I have a 2002 New Holland TC29 tractor. Recently I have Hydro Fluid leaking from the top of the bucket control block(?). I took the cover off and cleaned everything up and tightened all connections (most all were already tight) but I still have a small leak. Seems to leak when I am using the...

P.S. wished I had kept the old 8N just to drive it around if nothing else, but the better half said "Why do you need 2 tractors!" Did work good for grading. If you look close at my avatar you can just see the old 8N next to teh NH.

I also had an 8N (1952) and it also had a 6 volt (irritating) system. It's interesting because I bought my 8N from an older gentleman and I kept it for almost 20 years. I upgraded the 6v to a 12v system (pre-Amazon!) I believe I bought the kit from a place called Kennedy Tractors. I see now...

Thanks for eth tip. Checked McMaster-Carr, they have lots of potential solutions!!

THanks for teh link. THis looks like it would work fine and at 12" wide wouldn't leave too many seams! Thanks!!!

Thanks. I did look at the material at Lowes and HD but it only comes in a 4" strip. If I could find a 4 foot by 4 foot piece I can cut to fit but so far no luck. Really don't wnat to piece it together using 4" strips.....but if I have to I suppose I will. Gotta believe somewhere out there is...

Thanks! Not a show tractor. I was really looking for something anti-skid like it came with, just a thin material that I can put on with adhesive. Thanks again!

Hi all, I have a 2002 New Holland TC29 and the anti-skid material (where you feet go) is worn out. I went to the most local New Holland dealer (about 60 miles away) only to discover they have gone out of business (I was going that way anyway). I have looked on line for replacement material...

Hello All I was moving some dirt yesterday and rolled the tire on my TC29D off the wheel. The wheel has been bent since I bought it and I have always had to air it up before using. It's time for a new wheel! Based on searching the internet I believe the part number is 86525438. I am looking...

Hello All! Help. I have a 2002 New Holland TC29D. I recently went to the nearest dealer (about 70 miles away!) to get oil and filter for an oil change. The dealer parts guy gave me a filter which is way smaller than the one on the tractor. The dealer insisted it was the correct part number...

I have a TC29 and I need some more weight in the rear. When I use the box blade and it fills up with dirt I have to engage FWD since the back tires tend to spin. I don't want to put water in the tires. I called the NH dealer and they want $400 for a set of weights(105 lbs) Are there any other...

I just bought a used TC29. The seller said it was a 2002 model and under the hood is marked 2-2002 in some sort of marker. I am looking for the operators manual and/or service manuals. On line pdf files would be nice. I also am trying to confirm the year of the tractor. I am interested in...