Recent content by Ball Ground

Looks Nice. I did the same thing with a JD970 I previously owned. Got lazy when I bought the LS and just purchased the canopy from the dealer.

Very nice George2615. I installed "The Thumb" on my R3039 last year also but had to modify the bucket to in order to get the correct angle. I like the idea of mounting the thumb on pallet forks as well. Did you buy an extra mounting plate or just swap the entire unit out when changing over?

I might have missed it but has anyone come up with filter numbers for the R3039? I think the attached picture are the correct NAPA numbers for oil and air.

I am going to put up some sliding doors on my 50' x 36' shop and need some help deciding which way to go concerning the hardware. On one side of my shop I have a 12' x 9' opening and plan to use two 6' wide doors. On the other end I have a 9' x 7' opening and plan to use one 9' wide door. The...

Well, It took me forever to find the time but this is what I came up with for a toolbox. I'm not super happy with the actual toolbox itself but I like the location and mount. It does obstruct your visibility to the 3 point hitch just a little but no where near as bad as trying to look over...

Hello All, I'm a new R3039 owner but did lots of research here before I pulled the trigger and purchased it. Thanks for all the wisdom, advise, comments, etc... So far I'm pretty happy with it but right off I noticed a few things. I need a toolbox and want to replace the cupholder on the...