Recent content by Avpowerstn

Not to be out done by RRRoger...lol lol I heard an old farmers trick was to put some diesel in a spray bottle..remove the air filter and set the bottle to "mist" and give a diesel mist when trying to start a tractor where the fuel system has be "compromised?" instead of bleeding. I bleed my...

I just couldn't resist...problem solved.

Well said Gary...overkill it's like a disease. I think I found a truck to pull my trailer, and once again overkill steps in. This is a 5 ton..I think I can get a Deuce and a half for cheaper, registered as "historical" with no CDL required. Any input would be appreciated..Thank You

Hello Bdog I hope this helps (pic of pintle and hitch) I am assuming its a 15 ton pintle hitch..?? I called Draw-tite they said they did not make a class V receiver hitch..?

Thank You for the info. The gentleman I bought the trailer from pulled his Deere 310E backhoe (13K lbs) with his F-250 (standard hitch). He said his truck would drop about 6-8" when he cranked the leg up. I dropped about 2" (trailer was empty) with my F-350. I figured I needed a dump truck, the...

Hello everyone Just purchased a 1980 Miller Tilt bed for my Ford 545A any advice on how to adjust the load... I was told by a Trailer manufacturer that a hydraulic cylinder requires the axles to be placed too far forward, and that a scissor jack is best. But at 13K I went with the Old Miller...

Ok I have a seal kit for a B7200 HST-D loader (B1630),I have torn down the Lift Cylinder, but I am not sure , what goes where.My main question is "on the piston #1 there is a carbon ? ring, do I replace it with the yellow ring #2 (rigid) or the two piston rings #3. any help would be appreciated...

Hello EveryOne !!!! New to this site. Looks like a ton of information:licking: 1984 B7200 HST -D w/1630 Loader Gannon