Recent content by Arkhermit

I have a Hobart Handler 120. When you trigger the gun the contact won't stay closed and the wire feed motor won't run. However if you hook the motor wires to a battery it works. I am thinking the contactor is bad. I cleaned the points in it, nothing. Am I on the right track ?

I have a hyd pump that splines on pto shaft, which is max at 540 rpm, so my question, can I gear a small engine down with sprockets and roller chain to run it ? The engine is 11hp. would not this also up the applied power of the engine? Next question. I want to use a hyd cyl to raise and lower a...

I am thinking putting a 1986 1710 4X4 frt axle in another tractor and need to know what ratio it is ? How many turns of the pinion shaft for one rotation of the wheel ?

I have a 1980 5020 4X4 and the front axle is worn out. There is no repair for it. Due to the design of these, the pivots wear and there is no repair that I know of,so, Has anyone else had this problem ? How to fix it ? I am afraid it may be the end of the little tractor. I bought it new and it...

The lift arm shaft thru the differential seals leak and I heard that replacing seals won't fix it, that there is a kit that is needed to repair it. Has anyone run into this and know for sure? This seems like a poor design to me.

I have a engine block with crank, no rods or pistons, and head out of 1986 1510 Ford. It burned and I bought it for the front axle,(4X4) Inside the engine is still oilly and the paint is black, but not burned off. Open to offers, cash or trade. I am in North Arkansas close to Harrison.

I have read most of the posts here and you guys seem to have it together, so I have one for you. I have about a 30000# tulsa winch and I want to put on the 3pt on my JD tractor. Powered by Hyd pump hooked to pto The tractor hydraulics wouldn't be enough gpm I don't think ? So what size pump and...

1986 2350 leaks around shaft where lift arms attach. Is it simple as it looks ? Just remove arm and pop out seal and replace ? That was a dumb design to run shaft thru differ case.

I have a 2350 JD with hydr. steering. One of the cyls leaks, there is a small allen screw at the end of the cyl anyone know what that is for ? Is it to keep the shaft from coming out ? Thanks for any info

Does anyone know where I might find parts for an OLD Ingersol 1/2" impact ? I called the company years ago and it was too old for them to have parts for. I need a new anvil, this one is worn to the point it breaks sockets. I will get the model # and post it later, I was just reading another post...

I have a 820 John Deere and the shaft the lift arms attach to that runs thru the rear end housing leaks. I replaced the bushings but they did not fit tight at all I just pushed them in and the shaft slid in them no problem and they still leak. I think probably the shaft is worn and possibly the...

I have a two section pump,it is Cross brand and has 2479 stamped in the mounting flange. I have emailed the MGR but no responce. The inlets are 1" I looked on one site at a pump that looked about like this one and it said 40 gpm per section. I am building a firewood processor and need to run Hyd...