AnotherBueller's latest activity
-
AAnotherBueller reacted to CoveredWagon2's post in the thread Odd starting problem; Bobcat e42 excavator with
Good Post.
I had a similar experience with my 1986 Case 580SE Backhoe. My multi-meter showed 12v at the starter, remote battery lugs and battery... -
AAnotherBueller reacted to dodge man's post in the thread Odd starting problem; Bobcat e42 excavator with Good Post.
I’d get a load tester and learn how to use it. You never know if they know what they’re doing at the parts store. Just experiment with...
-
AAnotherBueller reacted to gengine's post in the thread Odd starting problem; Bobcat e42 excavator with Good Post.
A fully charged 12v battery should test at 12.7v-12.9v. The charging system, by way of the voltage regulator (built into the...
-
AAnotherBueller replied to the thread Kubota V1702 engine - Is 200-250 PSI too low compression to run?.While you are doing everything above listen for air leaks in the adjoining cylinders. This can help diagnose head gasket issues.
-
AAnotherBueller replied to the thread Kubota V1702 engine - Is 200-250 PSI too low compression to run?.In a compression ignition engine WITH a GLOW PLUG, using ether AKA starting fluid, is asking for damage to to the piston, valves and the...
-
AAnotherBueller reacted to thepumpguysc's post in the thread Kubota V1702 engine - Is 200-250 PSI too low compression to run? with Good Post.
I’ve seen small diesels run at 290 psi but not lower.. & they needed really long crank times. To check the fuel system.. a quick and...
-
AAnotherBueller reacted to rScotty's post in the thread Kubota V1702 engine - Is 200-250 PSI too low compression to run? with Good Post.
For any diesel compression test, be sure to use a Diesel Compression Gauge - it sounds like you have one. A diesel gauge normally goes...
-
AAnotherBueller reacted to Firemediceric's post in the thread Is a Tilt Trailer the right way for me to go? with Good Post.
Another piece of great advice that I would not have come up with on my own. Thank you.
-
ALooks really good! Great job!
-
AAnotherBueller reacted to Santa Craig Cringle's post in the thread Worst oil change ever with Good Post.
Building a new home/barn soon. Thinking about pre-staining the concrete with motor oil.
-
AHaven't read all 7 pages of responses, so, sorry if this has been said: If you don't have oil dry on hand, do you or your neighbors have...
-
ATwo words: Fluid Extractor. All my cars have cartridge oil filters topside at the front of the engines (German diesels, VW and MB) and I...
-
AI posted a thread ~ 2 years ago when my tractor blew a hydraulic line on a freshly paved asphalt driveway (figures). It left a 150’ long...
-
AMechanic clean shop dark arts: drop some mineral spirits onto that mess and scrub it in with a stiff shop broom and allow it to dry as...
-
AThought long and hard about retelling my hydraulic oil filter change... What the heck... It was just to change the oil filter, not all...