Recent content by ALKY

233tym Tractor has not run in years. Replaced fuel filter, pump, and injectors. Problem is it only runs smooth with #2 injection line cracked loose. Tighten it. It stalls. Foam is coming out. Ran fine for several minutes, tighten line it stalls. Any suggestions? Assuming it's in the injection...

when I turn my ign ccw to heat plugs indicator light comes on and back off. would that be the relay or something else?:confused:

I use a speeco wood splitter to power my cardboard baler.Recently,I topped it off with Wal-Mart hyd oil.When it gets warm it foams and makes soft cyl pressure[no compaction].It has a new pump and engine,so cyl and valve is all that is old.any thoughts or suggestions? THANKS:confused:

The other day my speeco splitter started pressurizing the tank with foamy oil.where could the air be coming from? I put on a new pump and suction line with no improvement.Also the new pump doesn't shift under pressure it stalls engine. same problem or completely different? thanks

need a copy showing gcwr of 1994 f-350 4dr dually 4x2 460 auto.i'm titling this inPA and want this for future combination tags.Ford dealer says to old for there data base. Please help! thanks:eek:

it looks like this

just wondering about mounting a receiver to my towbar.it extends hyd. and has 3 pin holes for up and down.do u guys think it would be legal to weld a hitch to it?The cylinder holds the weight when towbaring but is also safety chained. I appreciate all views but PLEASE don't bash me for asking...

Does anyone know what pressure the electric pump should make? thanks:confused:

anyone been around one? please share experience,as I'm considering buying one. thanks

lookin' to buy a ss. found a good lookin deere,anything to look for good or bad?:confused:

My diesel tractor needs injectors,can I just remove the old and put in new or do they need set? any help will be appreciated.:confused2:

runs fine at idle but misfires at WOT or when PTO is engaged . Is it the coils? It is a b&s 16hp twin. thanks:(

I am converting a PTO driven manure spreader into a conveyor for my recycling biz. Just wondering what size elec motor it would require.It has to move plastic bottles approx. 5 ft from the ground into my baler. THANKS:thumbsup:

I have a 233 with a mitsibishi diesel. It won't start cold w/o ether. the bussbar on the glowplugs shows battery volts. Does this mean the plugs are bad? thanks in advance.:)

JUST WONDERING WHAT TYPE COUPLING TO USE? PUMP IS VICKERS VANE 11 GPM. WILL IT WORK? NEW TO HYDRALICS. THANKS IN ADVANCE