Recent content by alaskanjdeere

Hi everyone, I've got a 4410 with 212hr. The fault light started flashin a couple weeks ago with (.--. short long long short) which appears to be MFWD speed sensor? So today I'm out working in 2 wheel drive and the front axle start making poping noises I check the fluid and its OK I started to...

I'm in the middle of a TNT project and have a question about the fluid. Do I have to add fluid to the rams and valve before I attach them to the tractors system? Does the air need to be bleed? Or do I just add fluid to the tractors main tank and cycle the valve and not worry about it? I'm tying...

I went to the dealer and they wanted $100.00+$40.00 for shipping. I decided I'd try making some out of heavy rubber from the base for a safety cone.

I have a 4410 with 48 BH. Today I ordered the TNT from John Deere But after I got home I removed BH and I don't think there is enough clearance between the rocker arms and the mounting plate for the Backhoe for the hydraulic cylinders. Does anyone happen to have this setup or know if it will...

Can anyone help. I tried over in the customzation link but did not get any help. I need the measurement of the bucket from the attachment to the end of the teeth? I have one on order but am looking for a thumb. The measurement needs to be with the bucket 90 degrees from the boom. See attachment...

I need the measurement of the bucket from the attachment to the end of the teeth? I have one on order but am looking for a thumb. The measurement needs to be with the bucket 90 degrees from the boom. See attachment. CDP Backhoe Thanks Shawn

Want to know what you think about it? They're asking $349.00 on there web site. Is it worth looking at or should I buy something different? I'll be using it on a JD4410 in soft dirt(SHOULD be no big rocks) Thanks Shawn

I've been reading all your post for the last two years learning as much as possible. Well I finally took the plunge and into the deep end I bought me a JD4410, ehydro,mid pto,430 fel,48bh,tnt,imatch,frontier3pt finish mower,tiller and box blade .Only bad part is I have to wait till mid May to...