aesmith's latest activity

That's a good idea, too late for me this time. But I might mark the fully closed line on the plastic if it doesn't actually close right up.

The inner can't pass right through the yoke and stick out the other side, if that's what you mean. The fixing pin is in the way, and is...

Just to illustrate that point here's the shaft after cutting 40mm off the outer and before cutting the inner. You can see only 15mm or...

That's always advised, but the two new shafts that I shortened both started off with the inner already shorter than the outer. So my...

Thanks. I read the 6" recommendation but don't think I'd be happy with anything remotely that short, give were taking about near to 36"...

Hi, Something that's been bugging me for a while, the shaft for the mower is a bit too long. It doesn't close right up, at the shortest...