Recent content by aba4430

Your running issues may be resolved, but check your hood for potential cracking. These hoods are known to crack and the warranty for replacement might not extend to 10 years for the hood. I have a 2023 purchased SA425 with ~160 hours now. I manipulate the hood very gingerly during checks and...

Could the oil pressure switch be faulty?

Philips ultinon H8/H16 led’s from AMZN for the Yanmar. Edit: Had the tractor out at night to check the light intensity out. Very impressed; good beam pattern and strong illumination.

Got to fix the rear wheel bearings on my 328Ci this week. having 2X of these delivered tomorrow from Rock Auto.

Back-up Eaton branded Generac 20KW generator ran for ~6 hours last night/ early morning due to power outage; hence inherent exercise. However, about 3 hours into the run, we got a note from our Utility company that power had been restored. The generator kept on running and the transfer switch...

Since we were getting tired of yanking out the watering hose from our attached garage and connecting it to another hose that was connected to the vegetable garden sprinklers a little ways off, I ordered the following parts to put together a 3/4" inlet wall sillcock for my better half: Woodford...

Last week I installed these powder coated screen guards (6" x 3' lengths) on our 40' X 30' detached garage; about 85 linear ft with a minimal manipulation wastage. Wanted to try something different around the house. The SS mesh gutter screen reviews are generally positive, but there are some...

Ordered 300’ of 6” wide SS gutter guard from Costco.

A pair of rear rotors for my 23 Titan from AMZN.

Congrats, great car. I have a 98 Z3 2.8 (M52) not the M version. Minor correction in the quoted post above Scootr; the 1998 Z3 M is equipped with a S52 3.2L motor. Enjoy.

Back-up 20KW Eaton (Generac) ran for @2 hours today due to a power outage. Inherent extended exercise other than the weekly 15 minute auto runs.

Some seat covers for my Rolls Royce :). The old ones from Costco were trashed. PS. It’s an 87 Brat

After I finished mowing today, I took some pictures of the air filter setup on my SA425. It looks similar to your setup and I am sure eventually it will start gouging a crease into the radiator top. There is minimal gap (~1 mm) between the housing and radiator. What I am going to do is get a...

I will post some pictures of my set-up later today. I do inspect the air filter periodically and have not noted any atypical issues with securement of the assembly. More later.

Would you be able to post some pictures of your set-up. I have a SA425 and believe the filter set-up is similar to that in a SA424. Pictures may help point out issues readily and make it easy for folks to provide feedback.