rswyan
Super Star Member
- Joined
- May 12, 2004
- Messages
- 11,389
- Location
- Northeast Ohio
- Tractor
- Kubota B2910, Cub Cadet Pro Z 154S, Simplicity 18 CFC, Cub Cadet 782
RS, hope you don't have too much difficulty getting the valves replaced.... I don't envy your project at all.... just because it involves plumbing... I hate plumbing!
Hopefully won't have to actually replace any of them, just rebuild.
Sure would be nice to have some new 1/4 turn ball valves in there though ... but that could get kinda pricey, considering that it would probably require copper unions as well.
The thing I hate the most about this, is just the working in confined spaces.
There a big electrical cable that runs within a couple of inches of that one valve and it's live. No real way to move it much.
Pretty sure don't want to be melting the insulation off that ... :laughing:
Good luck on the finishing ... :thumbsup: