Good Morning!!!! 64 @ 5:00AM. Sunny. High 81F. Winds light and variable.
The Red Flag Warning expired last night, but firefighters were busy again with three call outs, one on the north side of Oroville again that resulted in a brief evacuation for nearby residents. It was held to 10 acres, while the other two were much smaller. No word yet on the causes, but almost all of them so far have been caused by people doing things they shouldn't have been doing.
Power is still off but will likely be restored once the copters have had a chance to fly the lines. The next shutoff is shaping up for sometime Sunday, a stronger system that will likely last into Tuesday.
Fall is putting on quite the show for you this year, Ron. Thanks for sharing!
It's good to screw up once in a while, Don, if for no other reason than to remind folks that nobody's perfect.:laughing:
Glad you got some help, Drew, and best of luck at the DMV. A while back a buddy of mine gave me a couple KN95 masks, and after a little googling, I learned that there is a lot of variation in quality. There was one website put up by a university that listed test results for a large number of masks, many of which failed the N95 standard used here in the USA. The gifted ones looked like they are among the failures, so they sit here unused.
Lost a couple hours yesterday morning to YouTube watching wet blaster videos, RS. Seems like lots of home brew setups out there, but the same basic problems remain of keeping the grit out of areas where it doesn't belong, and removing metal plating from parts that need it. Dry blasting with ultra fine media will produce the same finish as the wet blasters with a lot less trouble.
Had to google Steiner 230, Kyle, and as usual, there were
lots of references here on TBN. Here's hoping you found a diamond in the rough!
Did some straightening up in the garage yesterday, uncovering some bench space but not enough. So more of that today. FedEx is supposed to show up with more security cams, enough to have one watching each side of the house. Not sure I'll get a start on mounting them, though, as all will need wires run up in the attic and it's still gets hot up there early in the day. The fairing I purchased for the white bike needs some repairs, so I'll probably get it cleaned up and get out the fiberglass to make a start on that.
TGIF gang!:drink: