Massey 1260
I just got finished changing the hydraulic fluid and filter on the rear end. Cranked it up and it started then died and won't restart, like low oil pressure .
No lights are on. That is if they work. Is there a special way to prime after a hydraulic change?
There is a fill port that looks like hyd port by battery. Not familiar with it. Looks like it goes to one side of what I thought was the injection pump. Hopefully I didn't goof anything up?
I tried pulling the diesel line off the port to make sure there was no water and it was getting diesel.
I just got finished changing the hydraulic fluid and filter on the rear end. Cranked it up and it started then died and won't restart, like low oil pressure .
No lights are on. That is if they work. Is there a special way to prime after a hydraulic change?
There is a fill port that looks like hyd port by battery. Not familiar with it. Looks like it goes to one side of what I thought was the injection pump. Hopefully I didn't goof anything up?
I tried pulling the diesel line off the port to make sure there was no water and it was getting diesel.