Where can I get a hand tubing bender?

[tomrscott]

Re: "Harbor Freight condut bender for schedule 40..."

Yeah, conduit and pipe are sized for the ID, while tubing is sized for the OD.

Also, this bender would make much wider sweep bend-radius than is required, and often useful, for hydraulic tubing.

But the price is right... /forums/images/graemlins/smirk.gif

 

[tomrscott]

http://www.harborfreight.com/cpi/ctaf/Displayitem.taf?itemnumber=3755

Here's one that might just do what I want, now if it only had 1/2".

Price is sure attractive. I know it will not be a Rigid equal, but I don't have a lot of work to do, so it really only has to get by for a few jobs. I will check with the local HF store tomorrow and see if these are in stock...

 

[Egon]

That looks like some some other benders of very good quality. At the price how can you lose?

Egon

 

[Soundguy]

I think I saw some at TSC as well as a small sheetmetal brake.

Soundguy

 

[tomrscott]

Far as I can tell, there isn't a single TSC in the entire state of Oregon.