PTO & Hydro N Safety Switch Connector Locations

   / PTO & Hydro N Safety Switch Connector Locations #1  

richief

New member
Joined
Mar 29, 2016
Messages
15
Location
S.E. Kentucky
Tractor
MF GC2610
Help, I am trying to figure out where the connectors are, for pto and tranny safety switches on a GC2610? Do I have to remove seat and tank to get at them? The Wires have no slack, they must be fastened/zip tied, and i am not wanting to blindly yank on them. Who has got at them before to ohm the switches at connectors, and can give me some insight on how long the pigtail to connectors are, where they’re routed, etc.? Wires are epoxied into switches and I am not fond of probing through insulation, not wanting to do that, I need to get at the connectors. Let me know please. Thanks in advance.
 
   / PTO & Hydro N Safety Switch Connector Locations #2  
on GC2400 I had to remove right rear tire to access the massey wire ties and connector on range (tranny) select switch.
never did pto side but bet its prob same setup.
the massey wire ties are releasable by pressing a tab on the wire tie.may be able to look up under rear of body and see if connector itself is visible.
way to cold here for me to see if thats option on GC2400 and even still...no idea if the 2400 same as 2610.
 
Last edited:
 
Top