Ford 4000 power steering question

   / Ford 4000 power steering question #1  

shawn1201

New member
Joined
May 9, 2011
Messages
10
Location
luling, Louisiana
Tractor
ford 4000
Good evening,

Ford 4000, 3 cyl diesel, 8 speed... I have the add on power steering with the power steering tank above the pump. I will be changing the two power steering hoses and to the cylinder tomorrow morning. After I replace them is there anything special I need to do to remove the air from them like bledding the hoses. If so , how is it done. Thanks
 
   / Ford 4000 power steering question #2  
Cycle the steering lock-to-lock a few times, checking the oil level in the reservoir as you go. If you can jack the front end up all or even part way, that will help.
 
   / Ford 4000 power steering question #3  
Good evening,

Ford 4000, 3 cyl diesel, 8 speed... I have the add on power steering with the power steering tank above the pump. I will be changing the two power steering hoses and to the cylinder tomorrow morning. After I replace them is there anything special I need to do to remove the air from them like bledding the hoses. If so , how is it done. Thanks

I don't know about your specific pump but just excercising the power steering will usually clear the air out of the lines. Normally there is no special bleeding procedure.
 
   / Ford 4000 power steering question
  • Thread Starter
#4  
Thanks guys, I'll change the hoses in the am then
 

Tractor & Equipment Auctions

Mk Diamond MK-101 Wet Tile Saw (A49461)
Mk Diamond MK-101...
2010 TROXELL 140BBL TRI AXLE VACUUM TRAILER (A50854)
2010 TROXELL...
2007 Toyota Camry Sedan (A48082)
2007 Toyota Camry...
SDLG WHEEL LOADER FORKS MAST W/ 48" FORKS (A51242)
SDLG WHEEL LOADER...
2018 INTERNATIONAL LT625 TANDEM AXLE DAY CAB (A51219)
2018 INTERNATIONAL...
2015 MACK GU713 DAYCAB (A50854)
2015 MACK GU713...
 
Top