Dickerson888
New member
- Joined
- Jun 1, 2010
- Messages
- 7
Foam filled tire rim on rear tine tiller turns inside tire. Any ideas?
Foam filled tire turns inside rim
- Thread starter Dickerson888
- Start date
- Views: 1410
5030
Epic Contributor
- Joined
- Feb 21, 2003
- Messages
- 28,967
- Location
- SE Michigan in the middle of nowhere
- Tractor
- Kubota M9000 HDCC3 M9000 HDC
Drill the rim and put in a couple sheet metal screws through the bead of the tire.
Not sure why you'd foam tiller tires anyway but whatever.
Not sure why you'd foam tiller tires anyway but whatever.
Gator6x4
Super Star Member
I would jack the rear or front up, put one of the ratcheted tie down straps around the tire and reflate the tire. I don't think sheet metal screws would with stand the force generated by the spinning rims inside the tire.
Gator6x4
Super Star Member
People who operate where there are thorny bushes or cactus like foam filled tires to prevent constant flats.
ROUSTABOUT
Elite Member
- Joined
- Jan 30, 2008
- Messages
- 3,186
- Location
- Luther Willis Hill, AR
- Tractor
- Pettibone, Ford, Massey Ferguson, International, JD, David Bradley, home mades
It is foam filled. There is no air, just foam.
ROUSTABOUT
Elite Member
- Joined
- Jan 30, 2008
- Messages
- 3,186
- Location
- Luther Willis Hill, AR
- Tractor
- Pettibone, Ford, Massey Ferguson, International, JD, David Bradley, home mades
Really depends if it has spray can foam or true tire fill. Anyway I'd put several screws in that rim. Because if you just put a few, and it slips, fixing that will be bad.
5030
Epic Contributor
- Joined
- Feb 21, 2003
- Messages
- 28,967
- Location
- SE Michigan in the middle of nowhere
- Tractor
- Kubota M9000 HDCC3 M9000 HDC
Keep in mind, it's a rear tine garden tiller not a tractor so I don't understand the need for foam filled tires in the first place.
Rustyiron
Super Member
If it will take air, it's possibly a 5 minute solution that's free and doesn't damage your rim.
I have a foam filled wheelbarrow tire…
It is only beneficial for folks that don’t like flats. Many people enjoy flat tires on their equipment for the challenge of keeping the air contained. To each their own.
Unless this is a prized machine, I’d drill the rim and use screws, just like drag race screws. Pretty simple process.
Rockbadchild
Elite Member
is it a big deal if it’s the case ? but a mix of tin screw and urethane windshield adhesive
