Connecting non-standard hitch to my tractor

   / Connecting non-standard hitch to my tractor #1  

plowhog

Elite Member
Joined
Dec 8, 2015
Messages
3,394
Location
North. NV, North. CA
Tractor
Massey 1710 / 1758, Ventrac 4500Y / TD9
I bought a Berkelman off road dump trailer a while back. I am just now wanting to put it into service for some firewood work.

I went to connect it to the tractor and ... whoa ... I'm not sure how to do it? Here is a pix of the front tongue of the trailer. The end section that will take a pin will spin 360 degrees?

How would you connect it up?

BerkelmanHitchA.jpg
 
   / Connecting non-standard hitch to my tractor #2  
Must be so if the trailer flips it won't flip the ATV?

On edit: Sorry I didn't know you have never used your draw bar before, I thought you were asking why it spins 360..
 
   / Connecting non-standard hitch to my tractor #3  
That's a standard draw bar setup. Just slip the drawbar in between the forks and slip a pin through it.
 
   / Connecting non-standard hitch to my tractor
  • Thread Starter
#4  
Thanks! I've attached implements but never used a drawbar. Now to see if I have one ....
 
   / Connecting non-standard hitch to my tractor #5  
Thanks! I've attached implements but never used a drawbar. Now to see if I have one ....



image-2836284101.jpg



If you don't have one of these sticking out from beneath the rear axle, you can purchase one of these and attach it to the 3 pt.



image-2600561670.jpg
 
   / Connecting non-standard hitch to my tractor
  • Thread Starter
#6  
Thanks! I know I have the second bar that is pictured. I'll connect it up tomorrow and see how it fastens up!
 
   / Connecting non-standard hitch to my tractor #7  
If you use the 3 point drawbar with a trailer, you need to chain the 3 point arms down or you can get in a situation where the trailer lifts the arms along with the bar. A belly bar is the best way to go with it.
 
   / Connecting non-standard hitch to my tractor #8  
You'll be more stable over rough/uneven ground if you go with a draw bar.
 
   / Connecting non-standard hitch to my tractor
  • Thread Starter
#10  
That is very helpful, thank you. I looked at several of their videos looking for something like this. Yes, this one shows exactly how to do it. Perfect.

UPDATE: I found my (cab) tractor has a belly bar. (Did not check the SCUT yet.) It was pushed all the way forward, invisible unless you crawl under the tractor. I extended it backward and it will be the perfect matchup for the trailer. Thank you all again.
 
Last edited:

Tractor & Equipment Auctions

2013 Chevrolet Impala Sedan (A48082)
2013 Chevrolet...
2016 Chevrolet Traverse LS SUV (A50860)
2016 Chevrolet...
ALL ITEMS NOT PICKED UP IN 30 DAYS WILL BE RESOLD FOR STORAGE!! (A50774)
ALL ITEMS NOT...
2016 Ford Escape AWD SUV (A48082)
2016 Ford Escape...
STORAGE FEES (A51219)
STORAGE FEES (A51219)
2016 Dodge Charger Sedan (A48082)
2016 Dodge Charger...
 
Top