Search results

R, you called the up/down device a SWITCH, does this switch allow the pump to engage, the device/SWITCH has a lever, and on the plate below an UP or DOWN POSITIONS, with the lever forward the dump goes UP, with the lever backward, the dump goes DOWN. Makes sense-SWITCH.

Thanks for all the advice. The PTO is on the driver side, and pulls up to engage the pump. First, the dump would not work at all, then I got under the truck and discovered that the UP/Down cable was against the manifold, and the cable had been slightly burnt. The cable is a multi-wire type...

Is the Hydraulic pump electrical? The PTO has a lever that has UP or Down, is connected to the pump with a wire cable, in the center is a smaller white insulated wire, I think that would indicate that the hydraulic pump is electrically controlled. Do I need a new control cable? How do I get...

D, I should have done that, when I added the cable ends with the two bolts, I did clean and scraped the ends with a wire brush, but still a NO START Problem. I did purchase new cable and a different cable end. The old connector ends with no metal/copper had me going crazy. The new ones work...

H, I think you are right, I may have bad cable ends, I added these ends some time back, and, although I did clean them good, and scraped them with a metal brush, the connectors may be bad. I will purchase new cables, will let you all know after I replace the older cables. Thanks!

J, I just recently purchased the battery at COSTCO (Internstate Batt}, my multimeter registers 12.9 V. K, I think I do have a cable problem, will check check voltage at the starter. D, I may have purchased a bad battery, I may have to return the batt. and get a new one.

Thanks to J, K, and D for your advice, I will check all of it out-Thanks again.

Thanks M, I appreciate your response-I will check and see where cables are connected to tractor body, and make sure "it's clean and will connected"

New battery & tested cables 12V Plus, will start quickly with power pac attached to cables on the battery; have cleaned the cable terminals, and are very tight on battery posts. What is goiing on? Have taken off cables from battery posts and re-tighten-several times. Tractor battery check on...