I am wanting to build an ATV/Riding mower creek bridge with some of the materials I have lying around.
The bridge would be 16' long and 4' wide, with an unsupported portion of about 12'.
I have been toying working with a windfall fir tree that I cut in half for the beams. These are shown...
In this video you can't hear me talking, but the problem is the throttle is very touchy. I barely touch it and it launches to full throttle. I tried lubricating several parts of the cable and linkages. It seemed to help a little. Is there anything else I can do to smooth it out?? I am basically...
I did some looking online (Youtube) for what people had done for a front mount ATV mower. I just started hacking this together and making up the design as I went along. I am not a fabber, not a welder, just like DIY (or being cheap) and try to learn what I can by making mistakes and improving...
I have a YM186D and have been working with member California on flipping the rear wheels so the dish is outboard (wider wheel stance) and he suggested I submit a new thread in case it might help other members. I am just trying this out...not an expert.
I believe that I need to remove the hubs...
My manual states that for a Sotah/Mitsubishi S373D Beaver III the 5-12 is correct for ag front tire. Currently, there is a very worn (not tread!) 5.00-12 Bridgstone (factory original?) tire and a 5.00-12 Starmaxx tire that had holes drilled in it :confused2: Anyhow, should I replace both with...
I am realizing that the 16 hp (13 pto) old Mitsubishi Beaver that I purchased will not be enough horse power to do what I need and it has no ROPS (I have hills) with no aftermarket ROPS available. I wanted to reach out to this forum for advice on what old Yanmar (probably a refurbished model) I...
Does anyone know if there is a ROPS kits for a Mitsubishi S373D Beaver III?
Closest I found is the following...
Mitsubishi & Satoh ROPS
but don't see anything listed.
Or is the best ROPS for these tractors not going on a hill and jumping off if it does start to roll? Too bad I have a...
I have a new to me pasture in front of the house that slopes down to the road. It is about 3 acres. I was walking around inspecting it and found a very deep hole filled with water. The hole was about 10" diameter but very, very deep. I have never seen anything like it. I did not want to push...
Hi,
I recently was able to fix the 3pt lift on my Beaver III. I was wondering if any of you can recommend a flail mower? The primary purpose is to mow about an acre of grass that is mostly groomed, but a little too rough in some spots for a riding mower to comfortably run. The secondary...
My new to me Beaver III is receiving lots of good service, almost replaced all fluids and applicable filters. One thing that I knew going in pre-purchase was the three point lift is stuck in the up position.
I did some work recently on it and removed the piston cover to get a view in there...
First of all, I really appreciate all of the good advice and community found on this forum. I am new here and hope to be a good community member and contribute at some point.
I bought a new to me Beaver III S373D 4WD this weekend and brought her home.
The primary purpose of this machine is...