Recent content by rjmack

\ I owned a tractor similar to that once, MF2135. it was an industrial version of a MF135. iirc it had a 3 speed trans w high and low range, an additional foot throttle, and the exhaust routed out below and the the rear of the tractor. and had power steering. I think pretty well everything...

You can pay a John Deere dealer to take a tractor home, but John Deere refuses to acknowledge that tractor belongs to you. this is so bizarre I really don't know where to post it. how about a poll to see just what farmers think of this? John Deere just told the copyright office that only...

like the title says, not too big of a deal though, less than 2 hours including re & re the loader to be able to get in there. hood comes off easy. gc241 broken hood mounts - YouTube

cement mixer. carport slab - YouTube

Well, I guess something had to break sooner or later. :laughing: have been doing a lot of digging/traveling over the last week. today the bucket curl system gave up the ghost. bucket will still curl relatively decent, but will not hold. requires constant pressure on the joystick while...

I posted a picture of this about 5 years ago and noticed it had over a thousand views but no comments. I called it a tool tote but things have worked out differently. I really only use it for mixing cement, but it has proven very handy for that. I can have a dump truck deliver the navijack at...

depends on what you are doing. for general yardwork my forks get used so much more often than hooks that its hard to make a comparison. 60-80 times as often wud be ballpark figure. bare bucket moving dirt is the one I least use, however I do have to remove the forks to use the bucket...

this is just one example. YouTube the hooks on mine get used quite often. no bracing has been required. it is usual much better to pull from the bucket end using the backhoe or whatever you have hanging off the back of the tractor for ballast.

built this over the last few years. https://www.youtube.com/watch?v=FKB0CbzodEM

Been working on this for a while. Built for Lincoln welder, using Miller welder. https://www.youtube.com/watch?v=FKB0CbzodEM

lol! I pulled the plugs, but the testing part was not necessary. I know the picture is crappy, but my phone lens is hooped. as you can see, the new ones are overall longer than the originals, the ends are all missing from the originals but they still seem to be full width down past where the...

Does anyone know if I can get a hotter than stock glow plug to fit on this engine? sick and tired of hard start even in summer. btw, also looking for an aftermarket block heater that will work. bad cord fried mine, buying from dealer will cost $235.00

another Massey Ferguson goes where no everlast welder has ever been seen. ?Tractor girl? drives Massey Ferguson to the South Pole - North - CBC News :laughing: :cool2::cool2::cool2:

still fun though. ?Tractor girl? drives Massey Ferguson to the South Pole - North - CBC News :dance1:

?Tractor girl? drives Massey Ferguson to the South Pole - North - CBC News :thumbsup::cool2: