Recent content by bigmarley98

I will not be back out until Sunday, so I can get an actual picture of the setup then, for now I have the stock image to show where the leak is coming from. To answer the other questions - correct, I have power coming into the P port, and power beyond adapter (from summit) for the N port, and I...

I have posted before about adding rear remotes using the Summit monoblock, primarily for top & tilt. Finally got around to it and finished it yesterday. Everything works as it should, but one small issue. When I first tested it, other than a few connections I had to tighten a bit more, there...

I am about to add rear remotes to my LX2610 - I already have a 3rd function and backhoe. I have it basically figured out (thanks to Dan/Thisoldhokie !) and found some information. The way the LX2610 is configured, PB off the loader valve goes to the third function, which then feeds the backhoe...

Thanks, based on a lot of the discussion I think I am going with Manual valves and getting float. Rather get it now and not use it, than not get it and wish I did.

Well, I did take the Cylinder off - not too bad, and didn't make too much of a mess. However, I think my problem may be different. After closer inspection I totally missed something - the bar accross the boom on the quick hitch is bent. Whatever I did bent that bar, and now the two sides are...

I was doing some work today with the Grapple and all of a sudden my loader was crooked. When I checked it the left side cylinder for curl was loose on the loader. The other right works and the bucket will curl, but no mater what position it is in the left side cylinder is loose and I am...

Thanks, that is helpful. The block I am looking to use is the Summit block (link below), it does have two work ports (P & T) that are normally plugged - I am guessing in that case I would run the P work port to the backhoe and return it to the T work port. It was my understanding when I did...

Long post, but bear with me, I want to add rear remotes to my Kubota LX2610. Yes, I have done some research and think I have the right solution, but want to run it by folks before I do. Important to note that I already have both a backhoe and a 3rd function valve installed. The backhoe is e...

Thanks, that helps - but while it answered my first question, it raised another that I thought I had understood :). I will think on that one but may have to post a different thread. Just when I think I am certain on the hydraulics there is a new wrinkle....

That's a good point. The return is probably not full pressure on the BH77 as there is likely a drop after the backhoe, but it is still only two lines, where the BH70 has three lines, and I believe the pressure in the third return to tank line is less than 25 psi. As you mentioned it might have...

So I am new to Hydraulics but am in the process of adding rear remotes to my LX2610 that would come off the power beyond supply lines I use for my BH77 backhoe. I think I have it figured out, but came across something doing my research that I would like to understand - I don't think I need it...