Search results

Don't know if this is of any use to you, but you shouldn't have to push the delete key very hard to get rid of it.

Not sure this is what you want or if I even got it attached.

Pay no attention to the date on the attachment. My camera kicks my butt on a regular basis. Picture was taken 10/29-2012

Here are some Kansas "Cattlemen". These are the guys who furnished some of my entertainment when I was a youngster. They would sit on the bench in front of the beer joint and tell horse stories. One of the stories I remember quite well was about the Texas "cowboys". They said if you give...

I hope I have attached a blurb from my 2084 cub cadet manual. It suggest the air gap should be .015". Different machine but I would expect the adjustment to be similiar.

Attached is a drawing of a sand bailer we made and used to put down wells near Wichita KS. I hope my drawing is good enough so you can tell what it is. We were in sandy country and only put down cased wells. This could also be used with a sand point but I think you would need to leave the...

This may be what you are dealing with. All down hole pumps with sucker rods that I have seen and worked on had a down hole piston assembly which in your case I believe is screwed/attached to the 2" dischare pipe. It appears to me your 2" pipe is likely in a larger casing. The piston is...

Since you don't need a lot of volumm, I think a very low HP piston pump would work very well. I have posted a picture of a pump similiar to what we used to pump water about 1/4 mile. We didn't have as high head pressure as you report but the old pump was bullet proof. Ours was run with a 1/4...

Here is another picture. Phone camera so quality is not the best.

We burned our CRP last Tuesday. This you see went up in smoke in about 5 minutes. We had spent about 3 or 4 hrs. backfiring the other side.

I attached the data sheet for the 1845C. It gives battery recommended capacity, but not physical size. I will relate my experience with battery installation. It is difficult with the loader boom arms down, but reasonable easy with the boom arms up and locked. I would run the machine on...

I got a Stealth Cam STC DVIR8 for Christmas. I like it but have not had enough experience to really make recommendations. It has been fun. I discovered it was hard on batterys, but purchased a larger battery and have been very satisfied since. The 6 D cell batteries were lasting about 3 days...

Everybody asks for pictures. This is a 5/8" transfer punch made from rebar as stated in a past post by me in this thread. This one has seen a lot of action and should last forever if it is only smacked hard enough to to make a mark to be enlarged by a regular center punch. There seems to be...

I had an uncle who used to manufacture ensilage gates that were automatic. No hydraulic or latches required . These gates were constucted with the hinge set a foot or more ahead of the rear of the dump bed. An 90 degree angle iron frame positioned the gate at the rear of the dump The gate's...

Here is some pictures of Kansas native grass planted in old tillable fields through the CRP program. I included my truck for a reference for size. What is in the picture is Big Bluestem. There is also Small Bluestem and Turkey Grass. In Kansas there is a requirement to burn CRP periodically...

Lucky me; I hope I have attached a picture of a carrier like I use on my 4 wheeler. I purchased this one with the expectation I could use it with other implements such as a row cultivater and field cultivator.

I am soon to recieve a John Deere 71 used Planter. I do not have a JD manual yet, but found a Yetter manual on line. I have read and been told that Yetters and John Deeres are alike. When I got to page 17 of the Yetter manual it lists MPH as part of the chart/equation for plant population. I...