Recent content by Scott Clearman

I'll be making plots this year, planting cow peas, clover and likely corn in a mix. I have a 35hp new Holland and a 5' tiller. What I don't have is a spreader or drill. What are folks using to spread seeds? I've used the handheld broadcasters and they area a pain, too many fill ups and lots...

Well, as a general rule I mow and plow in circles. so there's that....

******************UPDATE FOUND IT************** I found it, and it wasn't anything I had looked for or frankly had even been suggested, by that I mean it wasn't a connector pulled loose. It was a torn wiring harness, above the rear axel passenger side: This is what it looked like, the black...

Oh boy, this just wont end..... So, I'm still down. I have the service manual downloaded. going through the troubleshooting for the wont start issue, I've checked everything down to the control module. I have replaced the proximity switch on the forward/reverse lever because it did test out...

Thanks guys. The main issue is I get no voltage at all to the starter solenoid. It's not a low voltage issue, its no voltage. I have power to the starter, power to the fuse box, and power to the safety controller. I did find the proximity switch was not working, it did not complete the path...

UPDATE: So I got the manual and went through some tests. Found that the proximity switch on the forward/reverse shifter was bad. BUT, based on what I could see from the test procedure, I should have been able to use a jumper and bypass the switch. The bypass did not work, still no start. I...

2013

Update again: I bought a service manual. Im tired of swapping parts just to see. Now I have the schematics and guide. I'll let you know what I find.

UPDATE: Still down So far I have: changed relays charged battery removed ground cable and cleaned frame and connection, reinstalled Replaced the PTO switch (it needed it, it would go all around like a clock but still worked last time i checked) I have jumpered safeties (seat, clutch) but not...

I'm needing some help. I have a Workmaster 35, about a 2013 or so. Last time I drove it and all was fine, parked it with no issues. The next time I got on, within a few days, I turn the key and the starter won't engage. Turning the key on turns on all the gauges, lights, alarms but turning...