Recent content by BlueLS

I hope you brought this to the attention of that dealer.

Also try Original Cab Company.

I bought an auto darkening helmet yesterday and it made all the difference in the world.

I've always been a stick welder and decided to try a wire feed welder. This 125/120v is an entry level piece and I'm getting the hang of it. I was hoping it would do spot welding on sheet metal but even at it's lowest amperage setting, it just blows right through. Is that the way it is or is...

I’ve got a LB1100 hoe. It’s almost impossible to get grease into the boom swing cylinder pivots. New zerks are in place. I’ve even tried removing the pins to investigate but they won’t budge. I’m able to move the rod end ever so slightly on the pin. I’ve tried putting the hoe in about every...

😳

I'm surprised by the amount of responses.

I'm curious as to how many people on this site own one of these machines, gear driven and G3038's as well. If so, what year, how many hours and what repairs done, if any. I have owned my 2013 G3033H with 422 hours for almost 2 years and replaced all filters and the backhoe bucket curl hose.

Do you have one, if so, what's its condition, year and hours?

I bought a LS fuel filter #40006997 and received it. It's in a factory looking box. Are they typically wrapped in plastic film and is there an O-ring included for the water sensor?

You might try Michelle at CSSTractors.com

I had a hose made up recently for my LB1100 hoe at my local NAPA store. The original hose had a pin hole leak in the hose itself. I've never seen a pin hole before. Always figured they just blew out or were fine. The new hose was almost $70.

Anyone know if there's a website to lookup your tractor's VIN to find out the original dealer/location, service records, etc.?

Made these for the backhoe stabilizers. Steel was free so got about $10 invested. Nothing fancy but better than nothing.

I installed a Titian thumb and a pair of hooks on the bucket. Two very handy upgrades.